|Material:||Caston Iron||Type:||Self Centering|
|Jaw:||Three Jaws||Clamp Range:||200-1500mm|
|Clamp Force:||1500kg||Name:||Positioner Chuck|
self centering chuck,
4 jaw self centering chuck
The three-jaw chuck has three jaws, which can play the role of automatic centering and centering, suitable for clamping round parts.
Four-jaw single-action chuck can clamp square and special-shaped parts, and can easily adjust the center.
The three-jaw chuck is also called a three-jaw self-centering chuck. It determines the rotation center of the workpiece according to the circumference of the workpiece clamping part, but its centering accuracy is not very high. Generally according to the application, in the case of precision turning, grinding, and the use of universal indexing heads to mill parts with higher accuracy, the three-jaw chuck with higher clamping accuracy is selected, and the grinding required for rough turning and invisible position accuracy , Milling and other processing, using a three-jaw chuck with lower clamping accuracy.
Internal Range B
|WP200||200kg||30kg||ɸ 110-210mm||ɸ 20-130mm|
|WP300||250kg||120kg||ɸ 170-300mm||ɸ 20-190mm|
|WP400||350kg||240kg||ɸ 250-400mm||ɸ 120-250mm|
|WP500||800kg||600kg||ɸ 360-500mm||ɸ 200-340mm|
|WP600||1200kg||1000kg||ɸ 400-620mm||ɸ 150-410mm|
|WP750||1400kg||1000kg||ɸ 550-800mm||ɸ 380-580mm|
The chuck will be need replace, so we need to disassemble it. First, find a few (inner hexagon) screws from the back of the positioner chuck, remove it, and then use a wooden or copper rod from the front to the back. Hammering the disk inside the three claws will take out the disk. Inside is a small disc for positioning and dust protection. Remove it. After removal, find a few flat-head screwdriver screws at the corresponding positions behind the three claws of the chuck and remove it. This way, you can take out the bevel gear with the three claws, and then carefully remove the disk with the flat rectangular thread. Take it out and remove the three claws from the front, so that the three claws are removed. Generally, the interior is polished or cleaned after disassembly, and the flat rectangular threads are cleaned. The teeth on the back are often stained and cleaned. Try not to hurt it with a file or other hard, gently put it in after cleaning, hammer it with a wooden stick, then install the bevel gear shaft (this also needs to clean the dirt between the teeth), and screw in the screws that fix it. When installing the small discs and large discs on the back, carefully check whether their contact surfaces are bumped. Be sure to check them carefully. This is important to the accuracy of the entire chuck. Use a file to carefully remove unevenness. Finish the place, tighten the screws, and you're done.